5.1 parts of a racket, such as rule 5.1.1 to 5.1.7 above, all part of the specifications shown in Figure E. 5.1.1 racket by the handle grip, behind the string side, shoot first, shoot pole, connecting hose form the entire framework. 5.1.2 Grip the ball by holding the racket part. 5.1.3 string side is the striker shot for shot part. 5.1.4 racket head defines the scope face shot string. Rules 5.1.6 through 5.1.5 shaft to the parts described in connection with the racquet head shot. 5.1.6 Connection hose (if such a structure) and connecting rod shot head shot. 5.1.7 racket head, connecting pipes, and Grip shaft to general racket. 5.2 The total length of the film frame is not more than 680 mm, width not exceeding 230 mm. 5.3.1 film surface should be flat string, string through with making the first shot strings or other forms of cross woven. Deterioration of the pattern should be consistent, especially in the center of the film surface density of not less than other parts of the weave. 5.3.2 string side beat length not exceeding 280 mm, width not over 220 mm. 5.3.3 no matter what way the string taut film, shot strings provided to connect hose into his area does not exceed 35 mm, together with the region, including the entire film surface string is not over 330 mm long. 5.4.1 racket does not allow attachments and salient, except to prevent wear and tear, fracture, vibration, or adjust the focus of the appendages, or prevention of the racket handle to the Department and will sell the rope in your hand; but the size and location should be reasonable. 5.4.2 does not allow to change the provisions of the racket style.